Common problems and solutions of automatic capping machine

With the gradual strictness of packaging and the continuous transformation of packaging, people have also put forward higher regulations for capping machines. The working pressure size of capping machines has strict dimensions, from simple manual capping to fully automatic capping of mechanical equipment. Different levels of products such as high, medium, and low gears meet the satisfaction of customers with different levels of capping. Perform capping on glass bottles made of different materials.

Pursuing the integrity of perfect machinery and equipment, developing the automation technology level of machinery and equipment, so that our screw cap can better serve everyone's projects. Increase the time for machine and equipment to have no chance of failure control. Make our capping machine more widely used in strip packaging production lines. When choosing a capping machine, choose a large manufacturer to ensure the quality of the product.

Today, I have summarized four common problems and solutions for automatic capping machines for everyone:

The control switch is ineffective due to drift during the operation of a toggle switch or photoelectric switch. Such common faults can be resolved by adjusting the working position of the power switch or photoelectric switch, or replacing the power switch.

2. Electric winding and casing short circuit faults, as well as electrical wiring and wire joint short circuit faults, result in an external current during operation. This common fault can detect the motor on one hand, and check whether the relevant wires are loose on the other hand

3. The acceleration time setting of the capping machine is too short and the high-voltage electric shock volume exceeds the soft starter volume, causing common faults such as overcurrent during acceleration. The F001 value setting time can be moderately increased, and the volume of the electric shock cannot be changed arbitrarily.

4. The high operating voltage caused by excessive voltage transition in the power supply can be easily resolved by adding a series reactor to the switch power supply or moderately reducing the power supply voltage.