Hello, welcome to the official website of Shanghai sanhuai International Trade Co., Ltd!

National consultation hotline

+86-021-62411689

Matters needing attention when operating the emulsifier

Author: Click:527 Release time:2020-05-28

What precautions should be paid attention to when using the emulsifier?

When the emulsifying machine is placed in the customer's manufacturing workshop, the actual production will begin. Before using the emulsifier, we must first understand some precautions that should be paid attention to to prevent man-made accidents. We can check one by one from the following levels. After the check is over, we can start the next stage of manufacturing.

1. The power supply must be connected first, and the ground wire of the emulsifier must be connected reliably to ensure the protection of electricity consumption. Otherwise, disasters are likely to happen.

2. When the power is turned on, we need to move the homogenizing head of the rotary emulsifier to observe the turning of the homogenizing head. Looking from top to bottom, if it is rotated counterclockwise, it means that the power is connected correctly. If it is rotated clockwise, it means that the power is reversed and should be reconnected to the power supply.

3. The homogenizing head of the emulsifier is prohibited from idling in the absence of medium to prevent heat generation, burn out bearings and deformation of seals.

4. in the case of vacuuming, be sure to fill the vacuum pump water tank with water first to prevent the vacuum pump from idling. When the vacuum pump is started for the first time, it is necessary to check whether each vacuum pipeline is sealed to prevent air leakage and to prevent insufficient vacuum.

5. Before closing the vacuum pump, close the ball valve in front of the vacuum pump to prevent dew. When it is necessary to raise the lid of the pot, be sure to open the air filter first, let the pot body become normal pressure, and then use it up and down.

6. It is forbidden to open the vacuum pump without sealing the lid. If there are special circumstances, it should not be started for more than three minutes to prevent damage.

7. When the material needs to be heated, it is necessary to ensure that there is a heating medium in the jacket of the emulsifier to prevent dry burning and damage to the heating tube.

8. in the process of using the emulsifier, if there is abnormal noise, be sure to turn off the power immediately, and then use it again after the cause is found out.

9. During the operation of the emulsifying machine, it is forbidden to extend all parts of the body into the pot to prevent accidents.

10. When cleaning the emulsifying machine, be sure to cut off all the power before proceeding to avoid accidents.

+86-13386259279
  • Wechat:13386259279Wechat QR code